Fuel Level Rectangular Reed Sensor

Product Introduction

The fuel level sensor is a rectangular reed switch sensor that is used to measure the level of liquid in a container. The sensor consists of two parts: a float and a switch. The float is placed inside the container and the switch is mounted on the outside of the container. When the level of liquid in the container rises, the float rises with it and activates the switch. The switch then sends a signal to a control unit, which can be used to monitor the level of liquid in the container.

Product Advantage

There are many reasons to choose a reed switch sensor over other types of fuel level sensors. Here are some of the advantages of using a reed switch sensor:

1. High accuracy - Reed switch sensors can provide accurate measurements even in low-light conditions.
2. No power required - Reed switch sensors do not require any external power source, making them very easy to install and use.
3. Low cost - Reed switch sensors are relatively inexpensive compared to other types of fuel level sensors.
4. rugged construction - Reed switch sensors are built to withstand harsh environments, making them ideal for use in automotive applications.

Product Uses

This sensor is designed to be used in a fuel tank, and it can be used to measure the level of fuel in the tank. The sensor consists of a reed switch and a magnet. The reed switch is mounted on the outside of the tank, and the magnet is mounted on the inside of the tank. When the fuel level in the tank changes, the magnet will move up or down with the fuel level, and this will cause the reed switch to open or close. This will change the resistance of the circuit, and this can be measured by an external device.

FAQ

1. What is a fuel level reed switch sensor?
A fuel level reed switch sensor is a device that is used to measure the level of liquid in a container. The sensor consists of a float that is attached to a lever, which in turn is connected to a switch. When the float moves up or down, the lever activates or deactivates the switch.

2. How does a fuel level reed switch sensor work?
The sensor works by measuring the electrical resistance between two electrodes that are placed in the liquid. When the float moves up or down, the resistance between the electrodes changes, and this change is used to determine the level of liquid in the container.

3. How accurate are fuel level reed switch sensors?
Fuel level reed switch sensors are generally very accurate, with an error margin of less than 1%.

4. Where can I buy a fuel level reed switch sensor?
Fuel level reed switch sensors are available from many different manufacturers, and can be found online and in brick-and-mortar stores that sell electronic components.